杭州叉车CDD16-SC1是是一款3吨电瓶叉车，专门针对大件货物装卸而设计，配套蓄电池为24V230Ah，型号是24V3PZS345,又12只单体串联，采用国外进口技术板栅设计)叉车蓄电池在新电池使用前，应该完全地充满电，需要循环充放电多次以达至容量，在这段期间，叉车蓄电池容量暂时未达到状态，叉车蓄电池接线应该是完整无缺，并且要与蓄电池接线头紧紧联系。林德叉车蓄电池应用的时候或充电期间，透气锁盖（蓄电池盖）应该是正确地安装和锁紧。叉车蓄电池应时常存放在干净，没有尘埃及腐蚀的地方。科朗叉车蓄电池组如需要加注电解液，应该充电之后进行。如电解液水平充电之前已低于隔板，必须加进电解液大约1/8”高过隔板方可充电。
Hangzhou Forklift CDD16-SC1 is a 3 ton battery forklift,specially designed for the handling of bulky goods, the supportingbattery is 24V230Ah, the model is 24V3PZS345, and 12 units areconnected in series, using imported technology grid design)Forklift battery in Before using the new battery, it shouldbe fully charged, and it needs to be charged and discharged severaltimes to reach the maximum capacity. During this period, thecapacity of the forklift battery has not reached the best conditiontemporarily. The forklift battery wiring should be intact and mustbe connected to the battery. Connect the wiring head tightly. WhenLinde forklift battery is used or during charging, the breathablelock cover (battery cover) should be installed and lockedcorrectly. Forklift batteries should always be stored in a clean,dust-free place. If the battery pack of Crown forklift truck needsto be filled with electrolyte, it should be done after charging. Ifthe electrolyte level is lower than the separator before charging,you must add the electrolyte about 1/8" higher than the separatorbefore charging.
